Product Overview

Applications

Indoor application			Outdoor application
Substrate	Water absorption rate of tiles	Size of tiles	Substrate	Water absorption rate of tiles	Size of tiles
Stable substrate, such as mortar, concrete, brick, etc.	>0.2%	≤800mm×800mm/Tile	Stable substrate, such as mortar, concrete, brick, etc..	>0.2%	≤300mm×300mm/Tile
	>0.2%	≤300mm×600mm/Tile		>0.2%	≤100mm×200mm/Tile

Substrate Treatment: The surface should be firm, clean, no pollution, no wax stains, no concrete curing agent and other loose materials; Must wetting the surface before construction under the high temperature, dry environment, or the substrate is high water absorption. The surface roughness should be no more than 3mm within every 2m, if not match, please do the leveling operation or using the depth notch trowel to up to the roughness.

Mixing: Pouring 6.0~6.5 litre water into mixing barrel firstly, and then add the powder slowly while stirring with electric mixer until uniform and non-caking. After standing for 3 to 5 minutes, finally stir for 15~30 seconds to use. The whole tile adhesive mixture should be used up within 2 hours.

Technical Specifications

The adhesive complying with the standard requirements of C2T in JC/T547-2017 Adhesives for Ceramic Tiles. The main indicators are as follows:

No.	Testing items	Indicators
1	Tensile bond strength, MPa	≥1.0
2	Tensile adhesive strength after water immersion, MPa	≥1.0
3	Tensile adhesive strength after heat treatment, MPa	≥1.0
4	Tensile adhesive strength after freeze-thaw cycles, MPa	≥1.0
5	Tensile adhesive strength after placing for 10 min, MPa	≥0.5
6	Slip, mm	≤0.5

Construction Techniques

Application procedure: (Recommend floating method or buttering and floating method) Apply a thin layer of the tile adhesive to substrate with a straight edge trowel and then apply a thicker layer and comb with a notched trowel. The tile adhesive layer on the substrate should not larger than 1 m2 and the tiles should be pressed and rubbed onto the wet tile adhesive layer within 20 minutes. The tiles should be pressed onto the wet tile adhesive layer as soon as possible under adverse climate such as high temperature, wind, etc. Make sure the tile adhesives layer on substrate is still wet when fix tile on it. For tiles with deep backside grooves or larger than 300mm×300mm,  we recommend buttering and floating method( the adhesives should be applied on both the substrate and tile backside)

Announcements

During application, temperature should be 5℃~35℃; Avoid application in conditions such as rain, high temperature, wind, frost, etc.
Clear up the releasing agent on tiles’ backside before operation;
Tile joint gaps should be at least 2mm
Hold the notched trowel at an angle of approximately 60°from the substrate when combing.

Product Details

Net weight: 25kgs±